Australian Standard AS 2067-1984 Switchgear Assemblies and Ancillary Equipment for Alternating Voltages above 1 kV - Western Australia

Service summary

You will be required to comply with this Standard if you intend to undertake high voltage electrical installations.

You must ensure that any electrical work you do complies with the requirements of this Standard. This Standard provides minimum requirements for the design and erection of high voltage installations in systems with nominal voltages above 1 Kilovolt (alternating current) and nominal frequency up to and including 60 Hz, so as to ensure safety and proper functioning.

Please note that this Standard does not apply to the design of factory built, type-tested equipment for which separate Australian Standards exist to the extent of requirements covered by the standards. However, all other requirements of this Standard not covered by the type tests for the type-tested equipment must be complied with. In particular, ground safety clearances and section safety clearances must comply with this Standard.

Please consult the Contact Officer for more information and to ascertain the level of compliance that may be required.

Service type

Code of Practice

A code of practice can be either a legal requirement or non-legal requirement. Legal codes of practice are defined as a result of legislation. Non-legal codes of practice are defined by industry regulators and bodies.

Other resources

 Resources
Comply

Australian Standard AS 2067-2008 Substations and high voltage installations exceeding 1 Kilovolt - Please consult the Contact Officer for information on forms to be submitted.

Administering agency

Department of Commerce
EnergySafety

Act(s) name

Electricity Act 1945 (Western Australia)

Regulation(s) name

Electricity (Licensing) Regulations 1991 (Western Australia)

Contact details

General Enquiries
Department of Commerce
EnergySafety


Operating address:
Level 1, Mason Bird Building
303 Sevenoaks Street
Cannington
Western Australia 6107
Mailing address:
Locked Bag 14
Cloisters Square PO
Western Australia 6850

Phone:

08 62511900

Fax:

08 62511901
energysafety@commerce.wa.gov.au

Supporting information

Disclaimer

The information contained on the Australian Business Licence and Information Service (ABLIS) web site, or via packages or other sources is intended for general guidance only.

To the full extent permitted by law, the Federal, State, Territory and Local Governments make no representations or warranties (expressed or implied) in relation to the information, including its accuracy, currency or completeness.

The business information provided does not constitute professional or legal advice, nor is the use of any third party resource an endorsement of the information contained, the associated organisation, product or service. It is recommended that you obtain appropriate professional and /or independent legal advice to ensure that the material provided here is relevant to your particular circumstances.

To the full extent permitted by law the Federal, State, Territory and Local Governments, their employees and agents do not accept any liability for any reason, including without limitation, liability in negligence, to any person for the general information which is provided herein, or in respect of anything, including the consequences of anything done, or not done, by any such person in whole or partial reliance upon the information.