Australian Standard AS 2067-1984 Switchgear Assemblies and Ancillary Equipment for Alternating Voltages above 1 kV - Western Australia

Description

You will be required to comply with this Standard if you intend to undertake high voltage electrical installations.

You must ensure that any electrical work you do complies with the requirements of this Standard. This Standard provides minimum requirements for the design and erection of high voltage installations in systems with nominal voltages above 1 Kilovolt (alternating current) and nominal frequency up to and including 60 Hz, so as to ensure safety and proper functioning.

Please note that this Standard does not apply to the design of factory built, type-tested equipment for which separate Australian Standards exist to the extent of requirements covered by the standards. However, all other requirements of this Standard not covered by the type tests for the type-tested equipment must be complied with. In particular, ground safety clearances and section safety clearances must comply with this Standard.

Please consult the Contact Officer for more information and to ascertain the level of compliance that may be required.

Service type

Code of Practice

A code of practice can be either a legal requirement or non-legal requirement. Legal codes of practice are defined as a result of legislation. Non-legal codes of practice are defined by industry regulators and bodies.

Other resources

Task Resources
Comply Australian Standard AS 2067-2008 Substations and high voltage installations exceeding 1 Kilovolt - Please consult the Contact Officer for information on forms to be submitted.

Administering agency

Department of Mines, Industry Regulation and Safety

EnergySafety

Contact details

Contact Email, Phone and Address Details for this service in simple two column table format, header then data.

General Enquiries

Operating address: Level 1, Mason Bird Building
303 Sevenoaks Street
Cannington
Western Australia 6107
Mailing address: Locked Bag 14
Cloisters Square PO
Western Australia 6850
Phone: 08 6251 1900
Fax: 08 6251 1901
Email: energysafety@dmirs.wa.gov.au
Website: EnergySafety (Opens in new window)