Australian Standard AS 4041- Pressure Piping - Western Australia

Description

You will be required to comply with this standard if you intend to undertake gas fitting work and / or manufacture pressure piping.

A fitting line or fitting on a consumer's gas installation that is to operate at a pressure exceeding 200 kPa must comply with this standard (for above ground steel piping).

This standard sets out minimum requirements for the materials, design, fabrication, testing, inspection, reports and pre-commissioning of piping subject to internal pressure or external pressure or both. Specific requirements are given for piping constructed of carbon, carbon-manganese, low alloy and high alloy steels, ductile and cast iron, copper, aluminium, nickel, titanium and alloys of these materials. General requirements and reference to standards for non-metallic piping are included.

Please consult the Contact Officer for more information and to ascertain the level of compliance that may be required.

Service type

Code of Practice

A code of practice can be either a legal requirement or non-legal requirement. Legal codes of practice are defined as a result of legislation. Non-legal codes of practice are defined by industry regulators and bodies.

Other resources

Administering agency

Department of Mines, Industry Regulation and Safety

EnergySafety

Contact details

Contact Email, Phone and Address Details for this service in simple two column table format, header then data.

General Enquiries

Operating address: Level 1, Mason Bird Building
303 Sevenoaks Street
Cannington
Western Australia 6107
Mailing address: Locked Bag 14
Cloisters Square PO
Western Australia 6850
Phone: 08 6251 1900
Fax: 08 6251 1901
Email: energysafety@dmirs.wa.gov.au
Website: EnergySafety (Opens in new window)